B1838 BMW Fault Code

Description:

The Transmission Fluid Pressure Switch allows the engine's control module (PCM) or Transmission Control Module (TCM) to use hydraulic fluid to engage the clutches in the transmission to allow for smoother shifting while driving. If the PCM or TCM detects an issue with the hydraulic clutch or the pressure switch, the BMW PCM or TCM will set code B1838

B1838 Code Symptoms :

OBD B1838 code and tailpipe testing are two different approaches to identify vehicles in need of repair. The OBD system looks for broken or malfunctioning emissions control components and B1838, while tailpipe tests sample a vehicle's exhaust to see if it is above or below certain prescribed limits. Given the robust nature of today's emissions control components, it is entirely possible for an individual component to malfunction without leading to an immediate increase in emissions at the tailpipe.

In such cases, other components (like the catalyst) can temporarily compensate for the part that is broken however, these other components can only do double duty for so long before they, too, begin to malfunction. In addition, OBD also monitors for and other malfunctions in the fuel system problems that traditional tailpipe tests were not designed to identify. Most state and local areas also include a gas cap pressure test as part of an emission inspection.

Diagnosis And Repairing B1838

B1838 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to fix B1838 code ?

• Exhaust tube
• EVAP canister or fuel tank leaks
• 1Camshaft Position Sensor circuit poor electrical connection
• Fuel Injectors circuit poor electrical connection

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source.

Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.